Location And Assembly; Painting - Ecler IC Serie Bedienungsanleitung

5. LOCATION AND ASSEMBLY

would like to place the speakers and have the wiring necessary for each unit.
1.
2.
unit is separated into two parts, the outside part can be used as a template to make the hole in the
ceiling, and the inner disk can be used to protect the speaker cone if you would like to paint the
plastic another colour.
3.
4.
5.
6.

6. PAINTING

of the aesthetic criteria of the place where it will be used.
In order to paint any of the models in the product line:
1.
2.
3.
4.
6
Downloaded from www.Manualslib.com
To install this product correctly, you must be prepared to cut circular holes where you
In order to install the speakers correctly:
Remove the protective grating from the speaker using the hook provided in the packaging.
Cut a circular hole in the false ceiling.
A template for cutting/painting is included with each unit to simplify this process. Once the
Use the clamps to connect the unit to the wiring of the system where the speaker is being
installed.
Place the speaker in the newly cut hole. Hold it in place with your hand and push it into
place, all the while making sure that the three revolving fasteners are drawn back.
Press each of the three screws that are accessible from the front side of the speaker. The
speaker is now fixed in its final position.
Reattach the protective grille.
The IC series is designed to be painted, meaning it can be installed anywhere, regardless
Remove the protective grating from the speaker using the hook provided in the packaging.
Once the cut/paint template has been separated into two parts, use the inside disk to
protect the speaker cone. Place it tight on the cone. The points still on disk after it has
been separated help to fix it tight into place. The outside part of the template can be put
on the back part of the speaker, lining it up with the plastic circle, to protect the back part
from splattering if you are
using spray paint.
Paint the protective grating
and the speaker separately.
Make sure that the small
holes in the grating are not
blocked by paint. Use an
appropriate air-dry paint.
When the paint is dry, remove
the protectors. The unit is
ready to be installed.
manuals search engine