Technical Data; Noise And Vibration Information - Hilti DX 6 Serie Original Bedienungsanleitung

Fastening to concrete or steel
Description
minimum distance from the edge of the base material to the
fastener
minimum center-to-center distance between fasteners
minimum base-material thickness
3.9 Information about the field of applications
See the Hilti product page for more information about the areas of application.
4

Technical data

WARNING! Always remove the cartridge strip whenever work is interrupted. In this way you avoid
deformation of the plastic strip and the risk of injury due to self-firing in an overheated fastening tool.
When you work at the maximum fastener driving rate, allow the fastening tool to cool down after one hour of
constant work.
Weight
Length (fastening tool)
Length (fastener)
Recommended maximum fastening
rate
Required contact pressure
Compression stroke
Ambient temperature (storage and
use)
4.1 Bluetooth
Frequency
Maximum emitted transmission power
4.2

Noise and vibration information

The sound pressure and vibration values given in these instructions have been measured in accordance with
a standardized test and can be used to compare fastening tools with each other. They can also be used
for a preliminary assessment of exposure. The data given represent the main applications of the fastening
tool. However, if the fastening tool is used for different applications, with different accessories or is poorly
maintained, the data may vary. This can significantly increase exposure over the total working period. An
estimation of the level of exposure should also take into account the periods of time when the fastening
tool is not actually in use. This can significantly reduce exposure over the total working period. Prescribe
additional safety measures to protect the operator from the effects of noise and/or vibration, such as:
Maintenance of the fastening tool and its additional equipment or accessories, keeping the operator's hands
warm, organization of work procedures.
The noise values listed were determined under the following conditions:
Noise information conditions
Cartridge
Energy setting
Application
*2232121*
DX 6-F8
3.37 kg
475 mm
13 mm ... 72 mm
700 rev/h
174 N ... 200 N
19 mm
−15 ℃ ... 50 ℃
6.8/11 caliber, black
6
Fastening 24 mm wood to concrete (C40) with X-P47 P8
2232121
Concrete Steel
≥ 70 mm ≥ 15 mm
≥ 80 mm ≥ 20 mm
≥ 100 mm Follow the instruc-
tions in the operat-
ing instructions of
the fastener!
DX 6-MX DX 6-XIE-L
3.63 kg 3.43 kg
485 mm 547 mm
13 mm ... 72 mm 20 mm ... 140 mm
700 rev/h 700 rev/h
174 N ... 200 N 174 N ... 200 N
19 mm 19 mm
−15 ℃ ... 50 ℃ −15 ℃ ... 50 ℃
2,400 MHz ... 2,483.5 MHz
−27.2 dBm
English 25