Setting Up Power Supply - Bresser Thermo Hygro Quadro NLX Bedienungsanleitung

exchanged in only one of the devices (i.e. the remote
sensor) the signal can't be received or can't be received
correctly.
Note, that the effective range is vastly affected by building
materials and position of the main and remote units. Due to
external influences (various RC devices and other sources
of interference), the maximum distance can be greatly re-
duced. In such cases we suggest to position the main unit
and the remote sensor at other places. Sometimes all it
takes is a relocation of one of these components of a few
inches!
Though the remote unit is weather proof, it should be placed
away from direct sunlight, rain or snow.

8 Setting up power supply

Base device
1.
2.
3.
4.
5.
6.
7.
12 / 84
Insert the DC connector into the connection socket of
the base station.
Insert the mains plug into the power outlet.
The device is energized directly.
Wait until the indoor temperature is displayed on the
base station.
NOTICE! For permanent operation, mains power
supply is recommended. Alternatively a power sup-
ply with batteries is also possible, to keep the time
setting in case of power failure. Proceed as follows:
Remove the battery compartment cover.
Insert the batteries into the battery compartment. En-
sure that the battery polarity (+/-) is correct.
Replace the battery compartment cover.