Ricoh Pro L5130 Bitte Zuerst Lesen Seite 13

• Power Source
220-240 V, 16 A, 50/60 Hz (These values are for one power cord only.)
Two power cords are needed.
Please be sure to connect the power cord to a power source as above.
For users in Norway, this product is also designed for an IT power distribution system with phase-to-
phase voltage of 230V.
Handling the main machine
This section explains safety precautions about handling the main machine.
• Be sure to locate the machine as close as possible to a wall outlet. This will allow easy
disconnection of the power cord in the event of an emergency.
• If the machine emits smoke or odours, or if it behaves unusually, you must turn off its power
immediately. After turning off the power, be sure to disconnect the power cord plug from the
wall outlet. Then contact your service representative and report the problem. Do not use the
machine. Doing so could result in fire or electric shock.
• If metal objects, or water or other fluids fall inside this machine, you must turn off its power
immediately. After turning off the power, be sure to disconnect the power cord plug from the
wall outlet. Then contact your service representative and report the problem. Do not use the
machine. Doing so could result in fire or electric shock.
• Do not touch this machine if a lightning strike occurs in the immediate vicinity. Doing so could
result in electric shock.
• The following explains the warning messages on the plastic bag used in this product's
packaging.
• Keep the polythene materials (bags, etc.) supplied with this machine away from babies
and small children at all times. Suffocation can result if polythene materials are brought into
contact with the mouth or nose.
• Never open the center cover or raise the lever during printing. Opening the cover or raising the
lever will abort printing.
• Keep the center cover closed even when the machine is not printing. If not, dust can accumulate
on the nozzles in the heads.
Safety Information
9