Assembly - Makita DOLMAR PB-7660.4 Originalbetriebsanleitung

ASSEMBLY

CAUTION:
Before performing any work on the blower, always
stop the engine and pull the spark plug cap off the spark plug.
CAUTION:
Start the blower only after having assembled it
completely.
CAUTION:
Always wear protective gloves.
Assembling blower pipes
1. Insert the swivel pipe into the flexible pipe and tighten them with
the hose band.
2
► 1. Swivel pipe 2. Flexible pipe 3. Hose band
2. Loosen and remove the clamp screw.
► 1. Clamp screw
3. Install the control handle / handle assembly onto the swivel pipe
and tighten them with the clamp screw.
► 1. Control handle / handle assembly 2. Clamp screw
4. Attach the flexible pipe to the elbow
For tube throttle model: Insert the elbow to the flexible pipe. Attach
the cable holder between the hose band and the flexible pipe. Tighten
the cable holder, flexible pipe and elbow with the hose band. Set the
control cable onto the cable holder, and close the cable holder.
3
1
1
1
2
1
► 1. Elbow 2. Cable holder 3. Hose band
► 1. Cable holder 2. Control cable
For hip throttle model: Insert the elbow to the flexible pipe. Tighten
the flexible pipe and the elbow with the hose band.
5.
Attach the long/short pipe to the swivel pipe. Turn the long/short
pipe clockwise to lock it into place. Then attach the blower nozzle with
the long/short pipe. Turn the blower nozzle clockwise to lock it into
place.
1
► 1. Long/short pipe 2. Blower nozzle
6. Make sure all clamps are tight.
7 ENGLISH
3
2
1
2
2