Upgrading The Firmware - Hama PRN45HD Original Bedienungsanleitung

g

Upgrading the firmware

204
Downloaded from www.Manualslib.com
You can then view and edit the files stored on the hard disk of the ap-
pliance . In this way it is also possible to play back the files using the
network or to copy files between the PC and the appliance .
NOTE
► Ensure that the "SAMBA" function is activated in the setup
menu .
The firmware is installed in the appliance as operating system (OS). A
firmware upgrade means that new elements, improvements and fault
corrections are added to the existing operating system .
Proceed as follows to install a new firmware version:
Copy the file 'install.img' or the expansion files to the main direc-
‹
tory of the USB stick, then connect the stick to the USB port of
the appliance .
Switch off the appliance by pressing the ON/OFF button and
‹
disconnect the power cable of the mains adapter from the DC IN
jack on the rear side of the appliance .
Keep the ON/OFF button on the front of the appliance pressed;
‹
do not release it .
Connect the power cable to the DC IN jack and wait 15 seconds
‹
or longer . The release the ON/OFF button .
The firmware is installed. Information on another method of installation
can be found under "Changing system settings – Upgrading the
system" in chapter "Setup menu" .
NOTE
► New firmware versions can be found at www.hama.com
manuals search engine
Operation
PRN45HD