Sage the Dose Control Pro Kurzanleitung Seite 11

TROUB LESHOOTING
PROB LEM
G r i n d e r d o e s n o t
s t a r t a f t e r p r e s s i n g
START / CANCEL
b u t t o n
Mo t o r s t a r t s b u t
no ground coffee
c o mi n g f r o m
g r i n d o u t l e t
Ca n ' t a d j u s t t h e
G r i n d Si z e Co l l a r
Un a b l e t o l o c k
b e a n h o p p e r i n t o
p o s i t i o n
No t e n o u g h / t o o
much coffee grind
Portafilter overfills
Eme r g e n c y s t o p ?
POSSIB LE CAUSE
• Grinder not plugged in.
• Bean hopper not
attached correctly.
• Grinder has overheated.
• GRIND TIME dial is on
0 seconds.
• No coffee beans in
bean hopper.
• Grinder / bean hopper
is blocked.
• Grind Size Collar too tight.
• Coffee beans and grinds
caught in the burrs.
• Hopper not installed correctly.
• Coffee beans obstructing bean
hopper locking device.
• Grind amount
requires adjustment.
WHAT TO DO
• Plug power cord into power outlet.
• Lock bean hopper into position.
Refer to the Bean Hopper section
on page 6.
• Leave for 20 minutes to cool down
before using again.
• Rotate the GRIND TIME dial to
increase grind time.
• Fill bean hopper with fresh
coffee beans.
• Remove bean hopper. Inspect bean
hopper and burrs for blockage.
Refer to the Cleaning Conical Burrs
section on page 10.
• Rotate the Bean Hopper to turn the
Grind Size Collar to adjust grind settings.
• Run the grinder by pressing the
START / CANCEL button while
turning the Hopper.
• Unlock the hopper and install as per
instruction. Refer to the Bean Hopper
section on page 6.
• Remove bean hopper. Clear coffee
beans from top of burrs. Re-lock the
hopper into position & try again.
• Use GRIND TIME dial to fine tune the
amount more or less.
• It is normal for the correct amount
of coffee to appear overfilled in
your portafilter. Untamped coffee
has approximately three times
the volume of tamped coffee.
• Press the START / CANCEL button
to pause operation.
• Unplug power cord from
power outlet.
EN
1 1