Auto-Off Timer - Makita DCF203 Betriebsanleitung

Indicating the remaining battery
capacity
Only for battery cartridges with the indicator
► Fig.4: 1. Indicator lamps 2. Check button
Press the check button on the battery cartridge to indi-
cate the remaining battery capacity. The indicator lamps
light up for a few seconds.
Indicator lamps
Lighted Off
NOTE: Depending on the conditions of use and the
ambient temperature, the indication may differ slightly
from the actual capacity.
Adjusting fan head angle
The angle of the fan head can be adjusted manually. The adjustable range of the fan head is as shown in the figure.
► Fig.6
NOTICE:
Do not turn the fan head beyond the adjustable range.
Oscillating the fan head
CAUTION:
When oscillating the fan head, keep
obstacles clear of the moving range of the fan head. The
cordless fan may be pushed and fall by the oscillation.
CAUTION:
Do not stop the oscillation by holding
the fan head. Always press the oscillation button to stop.
Press the oscillation button to oscillate the fan head. Press
the button again to stop the oscillation. The fan head begins to
oscillate from the current position when the oscillation button is
pressed. The fan head oscillates in the range of 90-degrees.
► Fig.7: 1. Oscillation button
NOTE: Depending on the fan head position, the fan
head may not oscillate soon after the oscillation but-
ton is pressed because of the oscillation mechanism.
Remaining
capacity
Blinking
75% to 100%
50% to 75%
25% to 50%
0% to 25%
Charge the
battery.
The battery
may have
malfunctioned.
Appliance / battery protection system
The appliance is equipped with the protection system.
This system automatically cuts off power to the motor
to extend appliance and battery life. The appliance will
automatically stop during operation if the appliance or
battery is placed under one of the following conditions.
• Overload protection : When the appliance is operated in
a manner that causes it to draw an abnormally high cur-
rent, the appliance automatically stops without any indi-
cation. In this situation, turn the appliance off and stop
the application that caused the appliance to become
overloaded. Then turn the appliance on to restart.
• Overheat protection : When the appliance is over-
heated, the appliance automatically stops. Let the
appliance cool down before turning it on again.
• Overdischarge protection : When the battery
capacity becomes low, the appliance stops auto-
matically. If the appliance does not operate even
when the switches are operated, remove the
battery cartridge from the appliance and charge it.
OPERATION
Starting / stopping the fan
Press the power switch button to turn on the fan. Press
the power switch button again to turn off the fan.
Changing wind speed
Press the wind speed change button while the fan is run-
ning. The wind speed increases every time you press the
button. The wind speed will return to the lowest speed
when running in the highest speed. The cordless fan will
start in the same speed as the previous setting.
► Fig.5: 1. Wind speed change button

Auto-off timer

Press the auto-off timer button while the fan is running.
The duration to activate auto-off timer changes every time
you press the button (1 hour / 2 hours / 4 hours / off). The
number under each auto-off timer indicator shows the
remaining hour(s) to turn off the fan. The auto-off timer
indicator will turn off with time.
► Fig.8: 1. Auto-off timer button
NOTE: Depending on the battery cartridge type and
its remaining capacity, the auto-off timer may be
activated earlier than the set time.
9 ENGLISH