Technical Data - Bosch AVENAR keypad 8000 Installationsanleitung

44 en | Technical Data
The housing of the remote keypad must be open (see 03, page
6 ).
1.
2.
3.
Fixing the Ethernet cables to the housing
The housing of the remote keypad must be open (see 03, page
6 ).
If necessary, remove the controller (see 04, page 7 , step 6 and
7).
1.
2.
3.
Configuration
1.
2.
AVENAR keypad 8000 can be used as a redundant panel
controller in combination with AVENAR panel 8000, standard or
premium license.
5

Technical Data

Electrical
Minimum operating voltage
(VDC)
2020.05 | 8.0 | F.01U.347.558
Remove the controller to get access to the housing (see 04,
page 7 , step 6 and 7).
Attach the wires to the fixing points on the housing of the
remote keypad (see 09, page 12 , step 1).
Connect the shield wires to the screw terminal.
Fasten the Ethernet cables (see 12, page 16 ) with cable
ties to the controller and the housing (see 13, page 17 ).
Check the routing of the cables. They must not be crushed
or trapped.
If you have removed the device, then mount it again (see
09, page 12 , step 2 to 4).
For DIP settings, set the 6-pin DIP switch (see 11, page 15 ).
You can mark relevant information on the provided label.
AVENAR keypad 8000
13.2
Bosch Sicherheitssysteme GmbH