Important Notes - Unify OpenScape CP700 Installations- Und Kurzanleitung

Important Notes

For safety reasons, the telephone can only be supplied with
power as follows:
with the supplied original power supply unit
•
• using a LAN with PoE (Power over Ethernet) which sup-
ports the IEEE 802.3af standard
Never open the telephone. If you encounter any problems,
contact your technical support.
Use only original accessories! Using other accessories may
be dangerous, and will invalidate the warranty, extended
manufacturer's liability and the CE mark and other certifi-
cations.
Compliance with 2014/53/EU Radio Equipment Directive (RED):
In accordance with Article 10.8(a) and 10.8(b) of the RED, the follo-
wing table provides information on the frequency bands used and
the maximum RF transmit power of the product for sale in the EU:
CP700X
CP700X
CP700X
CP700X
CP700, CP700X Bluetooth 2402-2480
CP700X only: The device is restricted to indoor use only when ope-
rating in the 5150 to 5350 MHz frequency range in the following
countries: AT, BE, BG, HR, CY, CZ, DK, EE, FI, FR, DE, EL, HU, IE, IT,
LV,LT, LU, MT, NL, PL, PT,RO, SK, SI, ES, SE, UK.
RF Exposure Information (MPE):
This equipment should be installed and operated with minimum
distance 20cm between the radiator and your body.
Note (for USA only)
This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including in-
terference that may cause undesired operation.
This equipment has been tested and found to comply with the lim-
its for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular instal-
lation. If this equipment does cause harmful interference to radio
or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for
help.
Frequency bands
WLAN 2400-2483.5 MHz
WLAN 5150-5250 MHz
WLAN 5250-5350 MHz
WLAN 5470-5725 MHz
MHz
Power (EIRP limit)
Max. 20 dBm
Max. 23 dBm
Max. 23 dBm
Max. 23 dBm
Max. 20 dBm
,
9