Loading Pump Sets - Kangaroo Joey Bedienungsanleitung

Loading Pump Sets

Figure 5A. LOAD A SET opening
menu screen for Continuous
Feeding mode (EZ Pump Mode
not activated).
3. Grasp the MISTIC retainer end (black ring retainer) and wrap the tubing counterclockwise
around the rotor. Avoid overstretching the silicone tubing. (Figure 6B).
4. Carefully pull the MISTIC retainer end left and upwards to position it over the slot on the
left, and then lower the retainer into the slot. Push down on the retainer then release to
ensure proper engagement. (Figure 6B)
5. Push the valve's finger tab to the right to ensure proper seating.
6. Close the blue transparent door, checking to make sure the valve finger tab is captured by
the slot in the blue door.
Note: To avoid nuisance alarms, make sure the pump set exterior is free from droplets of
water or formula.
7. The top of the starting volume of formula should be 6 inches above the pump (Figure 4B).
Finger Tab
Pump Set Valve
Figure 6A.
Kangaroo™ Joey Enteral Feed and Flush Pump with Pole Clamp
The Kangaroo™ Joey enteral feed and flush pump with pole clamp will indicate LOAD A SET in the
screen's status line if a pump set is not installed. A blinking icon of a pump set will also appear in
the upper left corner of the screen. Figure 5A shows the screen for continuous feeding mode and
Figure 5B shows the screen for intermittent feeding mode (intermittent feeding mode not
available in EZ Pump Mode).
To load a pump set, follow the steps below:
1. With the pump display facing you, open the blue transparent door that encloses the
rotor and pump set loading area.
2. Load the pump set by holding the finger tab on the valve, then inserting the valve into
the valve slot on the left. (Figure 6A)
MISTIC
Retainer
End
Power
Valve Slot RetainerSlot Button
Set Loading Door
Figure 6B.
10
Figure 5B. LOAD A SET opening
menu screen for Intermittent
Feeding mode (EZ Pump Mode not
activated).
Table of Contents