Maintenance; Troubleshooting - GreenWorks 21277 Bedienungsanleitung

EN
DE ES IT FR PT NL RU FI SV NO DA PL CS SK SV HR HU RO BG EL AR TR HE LT LV ET

MAINTENANCE

REPLACING THE SPOOL (Fig.10 and 11)
Switch off and disconnect from the mains supply before
replacing, adjusting or cleaning your trimmer.
„ Press in both spool cover lock buttons (18), then
remove the spool cover.
„ Replace the spool and feed the nylon lines through the
eyelets (20).
„ Put the spool cover into position and push in until the
spool cover lock buttons clicked into the designated cut
outs and the spool is secured in place.
PROBLEM
Line will not advance when you
restart the machine.
Cutting head is hard to turn.
Grass wraps around the out put shaft
and the trimmer head assembly.
Line trimmer stops and will
not start again.
English (original instructions)
WARNING

TROUBLESHOOTING

POSSIBLE CAUSE
1. Line is welded to itself.
2. Not enough line on spool.
3. Line is worn too short.
4. Line is tangled on spool.
Grass wrapped or built up around
head.
Cutting tall grass at ground level.
1. Unit failed
2. Plug is damaged.
CLEANING THE LINE TRIMMER
„ Regular cleaning and maintenance of your grass
trimmer will ensure efficiency and prolong the life of
the unit.
„ After each cutting operation, remove the grass and soil
from the spool, the whole trimmer and the safety guard.
„ During operation, keep the air slots clean and free of
grass.
STORING THE LINE TRIMMER
„ Carry out general cleaning of the entire grass trimmer
and its parts to avoid the growing of mould.
„ Store it out of the reach of children, in safe and in a
dry place where the temperature is between 10 to 20
degrees Celsius.
SOLUTION
1. Lubricate with a silicone spray.
2. Install more line (Refer to "Replacing
the Cutting Line" earlier in this manual).
3. Pull lines while pressing release
button (17).
4. Remove line from spool and rewind
(Refer to "Replacing the Cutting Line"
earlier in this manual).
Clean affected parts of the machine.
Cut tall grass from the top down.
1. Contact dealer to check damage
2. Check the plug
3