Wireless Remote Controller; Maintenance - Toshiba MMC-AP0154H-E Installationsanleitung

Wireless remote controller

Always select
[ HIGH] air volume.
1
4, 5
1
1
Push (ON / OFF) button on the remote
controller, select [ COOL] or [
with (MODE) button, and then select
[ HIGH] with (FAN) button.
2
Cooling test run:
Set the temperature to 18 °C with (temp. setup)
buttons.
Heating test run:
Set the temperature to 30 °C with (temp. setup)
buttons.
3
Cooling test run:
After confirming a signal receiving sound "beep"
immediately set the temperature to 19 °C with
(temp. setup) buttons.
Heating test run:
After confirming a signal receiving sound "beep"
immediately set the temperature to 29 °C with
(temp. setup) buttons.
4
Cooling test run:
After confirming a signal receiving sound "beep"
immediately set the temperature to 18 °C with the
temp. setup buttons.
Heating test run:
After confirming a signal receiving sound "beep"
immediately set the temperature to 30 °C with the
temp. setup buttons.
5
3 4 5 6
Repeat procedures → → →
Indicators "Operation", "Timer", and "Ready" in the
wireless receiver section flash in approx. 10
seconds, and the air conditioner starts operation.
If any of these indicators does not flash, repeat
1
from procedure .
6
Upon completion of the test run, push
(ON / OFF) button to stop operation.
79-EN
Overview of test run operations using the wireless
remote controller
Cooling test run:
2, 3,
ON / OFF → 18 °C → 19 °C → 18 °C → 19 °C →
18 °C → 19 °C → 18 °C → (test run) → ON / OFF
Heating test run:
1,6
ON / OFF → 30 °C → 29 °C → 30 °C → 29 °C →
30 °C → 29 °C → 30 °C → (test run) → ON / OFF
HEAT]
.
10

Maintenance

<Daily maintenance>
▼ Cleaning of air filter
• If is displayed on the remote controller, maintain
the air filter.
1
Push the button to stop the
operation, then turn off the circuit breaker.
8
2
Open the air intake grille.
• Remove the screws of air intake grille fixing
knob on a side of each filter.
• Slide the air intake grille fixing knobs (two
positions) toward the arrow direction, and then
open the air intake grille.
Air intake grille
fixing knob
Air intake grille
Air filter
3
Take out air filter.
• Push the handle of the air filter, and remove the
hook of the air intake grille. Pull out the air filter
toward you.
Air intake grille
hook
Air filter
Air filter handle
Air intake grille
fixing hook Air filter handle
– 40 –
4
Cleaning with water or vacuum cleaner.
• If dust is heavy, wash it with tepid water
including neutral detergent or water.
• After cleaning with water, dry it completely in the
shade.
5
Mount the air filter.
1,7
6
Close the air intake grille.
• Close the air intake grille, and then fix it securely
while sliding knob toward you.
• Fix the screws of air intake grille fixing knob on
a side of each filter.
Air intake grille
fixing knob
Air intake grille
Air filter
7
Turn on the circuit breaker, then push the
button on the remote controller to
start the operation.
8
After cleaning, push .
display disappears.
CAUTION
• Do not start the air conditioner while leaving air filter
removed.
• Push the filter reset button. ( indication will be turn
off.)
80-EN