Timer Functions - Clatronic CL 3227 Bedienungsanleitung

current room temperature, the device switches the cooling
off and only the ventilator continues running.
NOTE:
The rate at which the desired temperature is reached depends
on the temperature of the room and the outside temperature.
Ventilator Speed
In the „cooling" and „ventilator" modes it is possible to set 3 dif-
ferent levels for the speed of the ventilator. The speed changes
with each press of the „
Red
Green – for a medium speed
Orange – for a slow speed

Timer Functions

Switch-off Timer
1. Turn the device on with the „ " button (J/13).
2. Briefl y press the „ " button (B/17) to change over to timer
adjustment. The digital display on the control panel fl ashes
and shows 00. The „ " control lamp lights up in green.
3. Press the button repeatedly to programme the timer. The
length of time is increased with every press of the button by
1 hour (00, 01, 02.....24, then from the beginning again).
4. After the set time has expired the device switches off.
Switch-on Timer
Before you use the switch-on timer turn the device on and set
the mode of operation, the ventilator speed and temperature.
The device displays the selected settings on the control panel
(Fig. 3).
1. Turn the device off with the „ " button (J/13).
2. Briefl y press the „ " button (B/17) to change to the time
setting mode. The digital display on the control panel fl ashes
and shows 00. The „ " control lamp lights up in green.
3. In order to programme the timer, press the „ " button (B/17)
repeatedly. The length of time increases by 1 hour with
every press of the button (00, 01, 02.....24, then from the
beginning again).
4. After the set time has expired, the device switches on.
If you would like to switch off the timer before the time has
expired, press the „ " button (B/17) repeatedly until the digital
display shows 00. The timer is now switched off.
Sleep Mode
Please wait until the device has begun operation as described
under the section „Switching on/off", or if the device is already
working, please proceed as follows:
• Press the „ " button (C) to switch on the sleep mode.
• In sleep mode the ventilation speed is preset to low (orange
lamp).
• The speed can be set or changed by pressing the „
button (G/15).
20
05-CL 3227.indd 20 05-CL 3227.indd 20
" button (G/15):
– for a high speed
• In sleep mode the previously selected temperature incre-
ases by 1°C after 1 hour and by a further 1°C after 2 hours.
• In order to switch sleep mode off again, press the „ " button
once more.
Dehumidifying
When the device is operated in the „dehumidify" mode you
should allow the exhaust air to fl ow back into the room.
During dehumidifi cation only the low ventilator speed is possible
(„ " control lamp lights up in orange). In this mode of
operation it may be necessary to empty the condensation
container more frequently (see section on „Emptying the Water
Container").
Air Outlet
• Press the „ " button (J/13) to open the air outlet.
• Press the „ " on (A/16) and the air outlet moves continuo-
usly up and down.
• The movement is stopped by repeatedly pressing the „ "
button and the air slit remains in this position. The direction
of the airfl ow is then constant.
• Once the „ " button has been pressed the air outlet closes.
Emptying the Water Container
Under conditions of high humidity it may be necessary to empty
the internal condensation container. When the water container is
full, an acoustic signal is heard 15 times. The device switches off
automatically and the „
order to empty the water container, please proceed as follows:
• Turn the device off („ " control lamp lights up in red) and
remove the plug from the socket.
CAUTION:
Do not move the device, as otherwise this might
cause the water to leak out and damage the fl oor,
carpet or device.
• Place the collecting pan supplied on the fl oor under the
outlet (12) of the device (see Fig. 5).
• Remove the rubber bung from the outfl ow and allow the
water to drain out (Fig. 6).
"
" (K) control lamp lights up in red. In
Fig. 5
Fig. 6
11.12.2007 10:09:09 Uhr 11.12.2007 10:09:09 Uhr