Functionality; Initial Use; Assembling The Fairy Lights; Installing The Fairy Lights - LIVARNO LUX 330981 1907 Bedienungs- Und Sicherheitshinweise

to be in the hands of children. Do not leave the
batteries lying around. There is a danger that
these will be swallowed by children or pets. If
they are accidentally swallowed seek immediate
medical attention.
CAUTION!
EXPLOSION HAZARD! Use only
rechargeable batteries of the recom-
mended type. Other rechargeable or single-use
batteries could explode during charging.
FIRE HAZARD! Never short-circuit
rechargeable batteries. Otherwise the
rechargeable batteries may overheat,
become a fire hazard or explode.
CAUTION!
EXPLOSION HAZARD! Never
throw rechargeable batteries into
fire or water.
Expired or drained rechargeable batteries may
leak chemicals which will damage the product.
Therefore remove the rechargeable battery if
the fairy lights will not be used for extended
periods.
WEAR PROTECTIVE GLOVES!
Leaked or damaged rechargeable
batteries could cause chemical burns
on contact with the skin; you should therefore
wear suitable protective gloves at all times if
such an event occurs.
Only use rechargeable batteries of the correct
size and and the recommended type (see section
"Technical data").
Make sure you fit the battery with the right po-
larity. This is displayed on the solar cell housing.

Functionality

The solar cell built into the product converts sunlight
into electricity and stores it in a LI-ION rechargeable
battery. The light switches on at dusk. The built-in
LED is an energy-saving illuminant with a very long
life. The light duration depends on the amount of
sunlight, the angle at which light hits the solar panel,
and the temperature (the battery capacity varies by
temperature). A vertical angle of light at temperatures
above the freezing point is ideal. The rechargeable
16 GB/IE
battery will only achieve its maximum capacity after
several charging and discharging cycles.

Initial use

Before first use, remove the protective film from
the solar panel .
1

Assembling the fairy lights

Insert the ground stake
housing (see Fig. A).
2
Place the light cover
so that the eyelets catch in the notches (see Fig. B).
Only model 10511A
Then, tighten the light cover
anticlockwise.
To loosen the connection, turn the light cover
clockwise from the base plate
Attach the ground stakes
by inserting the ground stakes
5
prefabricated notches on the underside of the
base plates and tighten them by turning them
5
counterclockwise.

Installing the fairy lights

Wear protective gloves when assem-
bling and setting up the fairy lights.
Ensure when setting them up that they are
securely positioned.
Push the ground stake
far enough into the ground (lawn, flower
1
bed) so that it is in a firm and upright position
in the ground.
Make sure it is firmly positioned. Do not use
any force when assembling or setting up the
product, e.g. hammer blows. This will damage
the product. In order to achieve the best result,
set the solar fairy lights garden set up in a place
into the solar cell
3
onto the base plate
4
by turning it
4
.
5
to the base plates
7
into the
7
for the solar panel
3
5
4