Technical Data - Dräger Alcotest 7510 Gebrauchsanweisung

Technical Data

» Set date «
Set with the , and keys.
M
Go back with the key.
OK
» Set time «
Set with the , and keys.
M
Go back with the key.
OK
» Set language «
Select with the , and keys..
M
Go back with the key.
OK
» Accuracy check «
After selecting the accuracy check with the
be used appears in the display.
Continue the procedure according to the messages in display. After
supplying gas to the instrument the result will be displayed, if
applicable the device functions will be locked/unlocked dependent on
deviation to target value.
» 50% charging «
Complete 50% charging of lithium ion batteries for periods of longer
storage.
50
Technical Data
11:53:47
04.12.17
Back to measurement
Show last tests
Electrochemical sensor
Show cal. dates
Set contrast/backlight
Show last error
Set date
Set time
Set language
Accuracy check
50% charging
03323996_01_en
, the test gas that must
OK
The display is identical with the measuring range.
If the measurement result is outside of the measuring range, three
arrows are shown in the display »    « = Measuring range
exceeded.
Measured value display for configuration acc. to EN 15964:
Measured value
0.0 mg/L to 0.03 mg/L
> 0.03 mg/L
Measuring Principle
Measuring range (Default setting)
Breath alcohol 0.00 to 3.0 mg/L
concentration
(Ethyl alcohol mass per breath volume
at 34
Blood alcohol 0,00 bis 6,00 ‰
concentration (Ethyl alcohol mass per blood volume
or blood mass at 20
By giving this data, a conversion factor
of 2100 is used between the breath
alcohol concentration and blood
alcohol concentration.)
Display Area
Display
0.0 mg/L
Measured value
Ambient conditions
during operation –10 to 50
10 to 100 % r.H. (non-condensing)
600 to 1100 hPa
during storage –40 to 70
Sampling
minimum blowing time adjustable
preset at 2 seconds
o
C and 1013 hPa.)
o
C and 1013 hPa.
o
C
o
C
Dräger Alcotest 7510