Operation; Safety; Putting Into Operation; Additional Information Ub 100 - Beurer UB 90 Gebrauchsanweisung

4. Operation

4.1 Safety

CAUTION
• This heated underblanket is equipped with a SAFETY SYSTEM. This sensor technology prevents
the entire surface of the heated underblanket from overheating by automatically switching off the
heated underblanket in the event of a fault. If the SAFETY SYSTEM has switched off the heated
underblanket, the temperature setting is not illuminated any more even when the heated under-
blanket is switched on.
• Please note that the heated underblanket is not operable any more due to safety reasons in this
case and has to be sent to the service address indicated.
• Do not connect the defective heated underblanket with another control of the same type. This would
trigger a permanent switch-off via the control safety system.

4.2 Putting into operation

• Spread out the heated underblanket flat onto your mattress
starting at the foot end.
• To operate the heated underblanket connect the Control to the
heated underblanket by plugging in the connector.
• Then plug in the supply plug into the mains outlet.
• Then put on your bedsheet in the usual manner so that the he-
ated underblanket is between your mattress and the bedsheet
CAUTION
Make sure that the heated underblanket is spread out
entirely flat and that it will not rumple up or crease when
in use.

Additional information UB 100

The area intended for the head cannot be heated.
Guide the plug-in coupling plug through the slot on the side sec-
tion [9] and then connect the Control to the electric underblanket
by plugging together the plug-in coupling [8] (see figure).
Then pull the side section over the sides of your mattress like a
fitted sheet. The electric underblanket is designed to fit 90 x 200
cm as well as 100 x 200 cm mattresses. If the cable length is
insufficient, you can order a longer power supply cord with the
material number 108.070 from our specified Customer Service.
Then fit your fitted sheet as usual with the electric underblanket
positioned between your mattress and the fitted sheet.

4.3 Switching on

Slide the ON/OFF switch [6] sideways [1] to the ON ( I ) position to switch on the electric underblanket.
When switched on, the display [2] lights up and at first displays all the segments for approx. 2 seconds. After
that, the following basic settings are displayed:
Temperature setting for body area: 0
Temperature setting for foot area: 0
Automatic switch-off time: 1 h (= 1 hour)
17