Jigsaw Safety Warnings - Sparky Professional TH 65 Originalbetriebsanleitung

ments, changing accessories, or storing
power tools. Such preventive safety meas-
ures reduce the risk of starting the power tool
accidentally.
d) store idle power tools out of the reach
of children and do not allow persons
unfamiliar with the power tool or these
instructions to operate the power tool.
Power tools are dangerous in the hands of
untrained users.
e) maintain power tools. check for misalign-
ment or binding of moving parts, break-
age of parts and any other condition that
may affect the power tool's operation. if
damaged, have the power tool repaired
before use. Many accidents are caused by
poorly maintained power tools.
f) keep cutting tools sharp and clean.
Properly maintained cutting tools with sharp
cutting edges are less likely to bind and are
easier to control.
g) Use the power tool, accessories and tool
bits etc. in accordance with these instruc-
tions, taking into account the working
conditions and the work to be performed.
Use of the power tool for operations different
from those intended could result in a hazard-
ous situation.
5. sErvicE
a) Have your power tool serviced by a quali-
fied repair person using only identical
replacement parts. This will ensure that the
safety of the power tool is maintained.
IV - Jigsaw safety
warnings
During operation provide eye protection to
prevent eyes from exposure to flying parti-
cles. Wear goggles.
Wear hearing protection during continu-
ous operation. Intense noise loading dur-
ing operation may damage the operator's
hearing.
Take protective measures against inhala-
tion of dust. Some materials can contain
toxic ingredients. Wear a dust mask and
work with dust/chip extraction.
Original instructions
pages-TH 65-65E-70E-R2.indd 5
▪ Do not process materials containing asbestos.
Asbestos is considered carcinogenic.
▪ Use of protective gloves is recommended.
WaRNiNg: Before connecting a tool to
a power source ensure that the voltage supply
is the same as the one specified on the name-
plate of the tool.
▪ A power source with a voltage greater than that
specified for the tool can result in serious injury
to the user, as well as damage to the tool.
▪ If in doubt, do not plug in the tool.
▪ Using a power source with a voltage less than
the nameplate rating is harmful to the motor.
▪ Fully unwind cable drum extensions to avoid
potential overheating.
▪ When an extension cable is required, you must
ensure that it has the right ampere rating for
your power tool and it is in safe electrical condi-
tion.
WaRNiNg: Always switch off and un-
plug the power tool prior to any adjustment,
servicing or maintenance or in case of mains
drop-out.
▪ Use clamps or a vice to secure your work when-
ever possible.
▪ While operating the machine, always hold it
firmly with both hands and provide for a secure
stance. The power tool is guided more securely
with both hands.
▪ Do not operate the jigsaw without the fence set
properly in its place.
▪ Keep hands away from the sawing range. Do
not reach under the workpiece. Contact with
the saw blade can lead to injuries.
▪ Apply the machine to the workpiece only when
switched on.
▪ When the cut is completed, switch the machine
off and then pull the saw blade out of the cut
only after it has come to a standstill.
▪ Take care that the base plate rests securely on
the material while sawing.
▪ Do not overload the machine: operate with mod-
erate pressure. Overloading occurs when you
apply excessive pressure, resulting in decrease
of motor speed, which may cause inefficient op-
eration and possible fault of the motor.
▪ Prior to sawing wood check the material for the
presence of screws or nails and remove them.
5
EN
20.10.2011 г. 15:31:44