Starting The Web Application - Guntermann & Drunck RemoteAccess-IP-CPU-Serie Installationsanleitung

Establishing a KVM-over-IP™ connection for the first time
Establishing a connection to the Transmission interface
How to connect a computer to the Transmission interface of the target module:
1. Use a category 5e (or better) twisted pair cable to connect the network interface
of any computer to the target module's Transmission interface.
2. Make sure that the IP address of the computer's network interface is part of the
subnet to which the IP address of the device belongs.
NOTE:
Use the IP address 172.17.0.100, for example.
3. Switch on the target module.

Starting the web application

How to configure the settings of the Transmission interface:
1. Start the computer's web browser and enter the URL
2. Enter the following data in the login mask of the target module:
Username: Enter a username.
Password:
Enter a password for your user account.
IMPORTANT: Change the administrator account's default password.
The default access data to the administrator account are:
 Username:
 Password:
3. Click on Login .
4. Click on the Config Panel 21
Configuring the Transmission interface
How to configure the settings of the Transmission interface:
NOTE: The Link Local address space 169.254.0.0.0/16 is reserved for internal com-
munication between devices according to RFC 3330. It is not possible to assign an
IP address of this address space!
1. In the menu, click on
2. Click on the target module and then click on
3. Click on the tab
4. Select the section
18 · RemoteAccess-IP-CPU series
Admin
See login information on the label on the bottom of the device
icon.
Remote Gateways
.
Network
.
Interfaces
172.17.0.10
.
Configuration
in the address line.
.