Installing The Projector On The Ceiling Mount; Basic Installation - Sharp AN-SV100T Bedienungsanleitung

Installing the Projector on the Ceiling Mount

Install the projector on the ceiling mount.
Line up the cut-out parts on the installation adapter with the bottom
of the height-adjusting pole, and hang the projector on the pole.
• Be sure the projector does not fall out of place.
Until properly anchored, the projector will remain freely suspended from the pole.
Screw in the vertical-angle adjustment bolts enough that they do not
fall out of place (two on each the left and right sides).
Vertical-angle adjustment
bolts M6 (12 mm)
•

Basic installation

For details on the correlation between projecting distance and display size, refer to the projector
operation manual.
Downloaded from www.Manualslib.com
Height-adjusting pole
Cut-out parts
Caution
Adjust the projector's vertical angle and then tighten the screws fi rmly.
manuals search engine
Vertical-angle adjustment
bolts M6 (12 mm)
17