Before Commissioning; Setting Up Power Supply - Bresser WIFI 4Cast Schnellstartanleitung

7 Outdoor temperature (°C/°F adjustable
globally)
9 Battery level indicator (base station)
11 'Feels like' temperature
13 Wind direction
15 Display of weekday, temperature values
and general weather forecast for the fifth
day
17 Indoor humidity (RH in %)
19 Indoor temperature (°C/°F adjustable glob-
ally)
21 General weather forecast for the second /
next day
23 Daily maximum temperature (°C/°F ad-
justable globally) for the second / next day
25 General weather forecast for the current
day
*if several sensors are connected (optional, not included)

7 Before commissioning

NOTICE
Avoid connection faults!
In order to avoid connection problems between the devices, the following points must be observed
during commissioning.
1. Place the base unit (receiver) and sensor (transmitter) as close together as possible.
2. Connect the power supply to the base unit and wait until the indoor temperature is displayed.
3. Establish power supply for the sensor.
4. Set up/operate the base unit and sensor within the effective transmission range.
5. Make sure that the base unit and the radio sensor are set to the same channel.
When changing the batteries, always remove the batteries in both the base unit and the sensor and
reinsert them in the correct order so that the radio connection can be re-established. If one of the two
devices is operated via a mains power connection, the power connection for this device must also be
disconnected briefly when changing the battery. If, for example, only the batteries in the sensor are re-
placed, the signal cannot be received or can no longer be received correctly.
Note that the actual range depends on the building materials used in the building and the position of
the base unit and outdoor sensor. External influences (various radio transmitters and other sources of
interference) can greatly reduce the possible range. In such cases, we recommend finding other loca-
tions for both the base unit and the outdoor sensor. Sometimes a shift of just a few centimetres is
enough!

8 Setting up power supply

Base device
1. Put the DC connector into the connection socket of the base station.
2. Put the mains plug into the power outlet.
26 / 56
8 Outdoor humidity (RH in %)
10 Outdoor sensor channel with symbol for
enabled wireless connection
12 Air pressure (hPa/mb)
14 Wind speed (km/h or mp/h adjustable)
16 Battery level indicator (outdoor sensor)
18 Display of weekday, temperature values
and general weather forecast for the
fourth day
20 Display of weekday, temperature values
and general weather forecast for the third
day
22 Daily minimum temperature (°C/°F ad-
justable globally) for the second/next day
24 Weekday display for the second / next day