Power-Saving Mode - Panasonic CF-VDM293U Bedienungsanleitung

NOTE
To remove a disc when the computer is powered off, insert a pointed object (e.g., the
bent-out tip of a paper clip, or the tip of a pencil or ballpoint pen) into the emergency
hole (C). Pushing it to the end allows the tray to come out.
If the vibration of the drive is excessive, check the disc. If the disc is normal and is
inserted correctly, set [CD/DVD Drive Speed] or [CD Drive Speed] to [Low] in the
[Main] menu of the Setup Utility (
setting does not work for the DVD disc when using CF-29C****** and CF-29D******
model.)
When writing to a CD using B's Recorder, set the writing speed [8x] or less.
For AutoPlay CD:
• If an AutoPlay CD does not start after the computer resumes from standby or hiber-
nation, remove the disc from the drive and then reinsert it after waiting 15 seconds.
• An AutoPlay CD may start during file access depending on the status of the disc.
When playing back video from a disc, playback may not be smooth in some conditions.

Power-saving Mode

If the drive is not accessed for 30 seconds, the drive motor will automatically be shut down to
reduce the power consumption. When the drive is accessed again, the drive motor is turned
on. In this case, reading of the disc data will take approximately 30 seconds.
Information
To play DVD-Video or MPEG2 files, install WinDVD using DVD Drive Utility Disc
(included). ( page 16)
Reference Manual "Setup Utility"). (This
E
9