Instructions For Use (English) - Philips M2741A Gebrauchsanweisung

Instructions for Use
1. Plug the sensor cable into the
monitor's CO input connector.
2
Allow the sensor two minutes
warm up time
2. Connect the cannula, airway
adapter, or sample line as
appropriate, to the sensor. It
will click into place when
seated correctly.
3. Zero the sensor.
For intubated patients requiring
4.
an airway adapter:
Install the
airway adapter at the proximal
end of the circuit between the
elbow and the ventilator Y-
section.
For intubated patients with
an integrated airway adapter
in the breathing circuit.:
Connect the male luer
connector on the straight
sample line to the female
port on the airway adapter.
For non-intubated patients:
the patient.
6
Place the nasal cannula onto