Herunterladen Inhalt Inhalt Diese Seite drucken

Cleaning - Rowi HKH 2000/2/1 ODT PREMIUM Originalbetriebsanleitung

Keramik-heizlüfter 2000 w
Vorschau ausblenden Andere Handbücher für HKH 2000/2/1 ODT PREMIUM:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

5.2 Cleaning

The appliance should be covered after
each use to prevent contamination by
impurities.
Attention danger!
Wait until appliance has cooled down
before covering or putting it away.
If the appliance has nevertheless become
dirty, observe the following notes during
cleaning:
Always clean the appliance while cool.
X
Pull out mains plug before any work.
X
Only clean the appliance with a dry,
X
soft cloth. Never use strong and/or
abrasive cleaning agents.
5.3 Maintenance
Note that only original parts may be
used for repair and maintenance work.
Contact the ROWI Service Center if need
be (see Chapter 6).
Replacing the battery
The battery (3 V lithium battery CR2025)
is not included in the scope of supply. To
insert/replace the battery, you need to
open the battery compartment on the
rear of the remote control.
5.4 Troubleshooting
FAULT: Appliance does not start.
Possible cause
No power or
voltage too low.
GB
28/48
Remedy
Make sure the
plug is plugged
into the socket.
Check the power
supply voltage.
The appliance is
not switched on.
The room tempe-
rature is above the
temperature set at
the thermostat.
The tip protection
switch has
triggered
The Standby
button was not
pressed after
switching on the
ON/OFF switch
FAULT: The switch switches off during
operation.
Possible cause
The thermal pro-
tection switch has
triggered. The
appliance has
exceeded the
maximum
permissible
temperature.
The room
temperature is
above the tempe-
rature set at the
thermostat.
Operate the
main switch and
press the Power
button
Increase thermos-
tat temperature.
Make sure the
appliance is in a
vertical position
and not exposed
to any extreme
inclination.
Press the Standby
button,
Remedy
Switch off the
appliance by
operating the
ON/OFF switch
and pull the
plug out of the
socket. Allow
the appliance to
cool down for
several minutes.
Check the air inlet
and air outlet
openings and
remedy the cause
of the overheating
before restarting
the appliance.
Increase the
thermostat
temperature.

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

1 03 03 0353

Inhaltsverzeichnis