Installation & Mounting; Maintenance - LD Systems DDQ Serie Bedienungsanleitung

ADJUSTING THE SM707 CABINET FLANGE
The built-in, patented SM707 cabinet flange is highly adjustable.
The SM707 permits angles of between + und - 13.5° in increments of 4.5°.
Carefully lift the cabinet a little (approx. 0.5 cm) to unlock the locking mechanism, then tilt the cabinet to the
desired position and lower it again.
FLOWN OPERATION:
The speakers are equipped with appropriate flyware for flown operation.
The LD DDQ series speakers have M8 threads for use with M8 eyelet bolts, which can be used to suspend the
speakers
on chains with snap hooks or wire ropes.
Please use only appropriately certified, undamaged flyware (flying points,
eyelet bolts, snap hooks, chains, wire ropes, etc.). Please also observe the corresponding requirements
for flown operation above persons in correspondingly applicable regulations (varies from country to country)!
As an alternative to flying points, the speakers can be flown using the LDDDQ10SB and LDDDQ12SB swing bra-
ckets developed especially for the LD DDQ series. The assembly instructions can be found on the next two pages
of this user's manual. The swing brackets can be fastened securely to crossbar systems, for example, using the
optional Adam Hall SCP838 "self-lock" hooks.

MAINTENANCE:

The best way to clean the surface of the loudspeaker's cabinet is to use a dry, medium-hard brush (wallpaper
brush). Use only a dry cloth to clean the control panel.
INSTALLATION & MOUNTING:
Pivot point
+/- 13,5°
Tilt cabinet to the
desired position.
Lift cabinet
Caution! Please hold the
cabinet securely!
Lower cabinet again.
13