Operating Information; Mounting / Installation - LD Systems SAT-Serie Bedienungsanleitung

OPERATINg INfORMATION:

PASSIVE SPEAKER
lD SAT42(W) / SAT242(W)
Up to 4 SAT42(W) (up to 2 SAT242(W) ) loudspeakers per power amp output can be connected in parallel on 4
ohms. At the rear connection terminal, the loudspeaker signal is simply looped through to the next SAT42(W)
(SAT242(W) ) speaker.
lD SAT62(W)
Up to 4 SAT62(W) loudspeakers per power amp output can be connected in parallel 4 ohms. At the rear connec-
tion terminal, the loudspeaker signal is simply looped through to the next SAT62(W) speaker.
lD SAT82(W)
2 pieces of SAT82(W) loudspeakers per power amp output can be connected in parallel 4 ohms. At the rear
connection terminal, the loudspeaker signal is simply looped through to the next SAT82.
lD SUB88 in connection with the lD SAT 42/242/62(W)
Connect the loudspeaker cables coming from the power amplifier to the subwoofer connection terminals labelled
Input A and B. Then connect the satellites SAT42/242(W) or SAT62(W) to the connection terminals labelled Output
A and B. Up to 4 SAT42(W) / SAT62(W) or up to 2 SAT242(W) satellites can be connected in this combination on
4 ohms. We recommend loudspeaker cables such as the Adam Hall KLS 215, with a cross-section of at least 2 x
1.5 mm².
AcTIVE SPEAKER
lD SAT62A

MoUnTIng / InSTAllATIon

It is recommended to switch the system to ON as the last one and to OFF as the first one to prevent start-up
noise caused by a connected device like a mixer etc.. Additional connected LD SAT62A should be switched to ON
in order from the first to the last one and should be switched to OFF in reversed order. If the AUTO mode is used
the source should be turned to off only after 10 minutes without any signal to make sure, that the connected LD
SAT62A are in Standby mode.
connEcTIng AnD oPERATIng
To connect the LD SAT62A the device should be turned to OFF. There is a connection using 6.3 mm jacks (ba-
lanced triple pole / unbalanced two pole) possible as well as a balanced connection using triple pole XLR plugs.
After connecting all necessary cables and the MAIN LEVEL adjust is turned counterclockwise to left end stop the
source device can be turned to on. Then the LD SAT62A can be turned to ON too (see above). Please turn the
MAIN LEVEL adjust clockwise until designated level is reached. Please do so for additional LD SAT62A if used.
The Connection and operating elements of LD SAT62A are shown on the back panel active speakers page.
SIgnAl looPIng
The LD SAT62A system is designed to loop the signal to additional devices via triple pole XLR cable. It is not
necessary to connect each device using an own connection to the source. Please make sure that XLR cables of a
good quality are used and that the cables are installed in safe way.
6