ASROCK H61M-DG3-USB3 Installationsanleitung Seite 19

Downloaded from www.Manualslib.com
Print Port Header
AFD#
ERROR#
(25-pin LPT1) PINIT#
SLIN#
(see p.2 No. 18)
1
SPD1
SPD0
STB#
Front Panel Audio Header
(9-pin HD_AUDIO1)
(see p.2 No. 19)
1. High Defi nition Audio supports Jack Sensing, but the panel wire on
the chassis must support HDA to function correctly. Please follow the
instruction in our manual and chassis manual to install your system.
2. If you use AC'97 audio panel, please install it to the front panel audio
header as below:
A. Connect Mic_IN (MIC) to MIC2_L.
B. Connect Audio_R (RIN) to OUT2_R and Audio_L (LIN) to OUT2_L.
C. Connect Ground (GND) to Ground (GND).
D. MIC_RET and OUT_RET are for HD audio panel only. You don't
need to connect them for AC'97 audio panel.
E. To activate the front mic.
For Windows
Select "Mixer". Select "Recorder". Then click "FrontMic".
For Windows
Go to the "FrontMic" Tab in the Realtek Control panel. Adjust
"Recording Volume".
System Panel Header
(9-pin PANEL1)
(see p.2 No. 14)
Connect the power switch, reset switch and system status indicator on the
chassis to this header according to the pin assignments below. Note the
positive and negative pins before connecting the cables.
PWRBTN (Power Switch):
Connect to the power switch on the chassis front panel. You may confi gure
the way to turn off your system using the power switch.
ASRock H61M-DG3/USB3 Motherboard
manuals search engine
This is an interface for print
port cable that allows
GND
convenient connection of printer
devices.
SPD7
SPD6 ACK#
SPD5
BUSY
SPD4 PE
SPD3 SLCT
SPD2
This is an interface for front
GND
PRESENCE#
MIC_RET panel audio cable that allows
OUT_RET
convenient connection and
control of audio devices.
1
OUT2_L
J_SENSE
OUT2_R
MIC2_R
MIC2_L
®
XP / XP 64-bit OS:
® TM TM
7 / 7 64-bit / Vista / Vista 64-bit OS:
This header accommodates
several system front panel
functions.
19