Inhaltsverzeichnis - SPL Channel One 9945 Bedienungsanleitung

Inhalt
Einleitung ........................................................................................................................ 4
Grundsätzliches ........................................................................................................... 4
Inbetriebnahme/Sicherheitshinweise ............................................................... 5
Anschlüsse:
Rückseite/Verkabelung ................................................................................................ 6
Allgemeine Hinweise, Buchsen .................................................................................. 7
Bedienung:
• Vorstufe
Microphone Gain, 48-Volt-Phantomspeisung, Phase Reverse, Highpass ..... 9
Instrument Gain, Zur Aussteuerung, Instr./Line On - MicOff, Instr. Input .......10
• De-Esser
On, S-Reduction, Die Technik des Auto Dynamic De-Esser ...............................11
• Insert
Insert ..................................................................................................................................12
• Kompressor/Limiter
On .......................................................................................................................................12
Limit, Gain Reduction, Noise Gate ............................................................................13
Make Up, Zur Technik des Kompressors ..................................................................14
• Equalizer
On, Pre Comp., Air Band ...............................................................................................15
Mid-Hi Band, Cut/Boost (Mid-Hi), Low Band, Cut/Boost (Low) .........................16
Tip zur Frequenzeinstellung, Distortion .................................................................17
• Output
Output, Mute ..................................................................................................................18
• Headphone Monitor
Playback, Volume, Phones ...........................................................................................19
• Anzeigenfeld
S-Detect., Clip, Signal, Warm Up .................................................................................20
Gain Reduction, PPM-Output .....................................................................................21
Stromversorgung ........................................................................................................21
Technische Daten .........................................................................................................23
Blockdiagramm ............................................................................................................24
Messungen .....................................................................................................................25
Garantie ...........................................................................................................................26
Kopiervorlage ...............................................................................................................27
Notizen .............................................................................................................................28
3