Scandomestic SFO 2203 W Bedienungsanleitung Seite 22

Connection Of Drain Hoses
Insert the drain hose into a drain pipe with a minimum diameter
of 4 cm, or let it run into the sink, making sure to avoid bending
or crimping it. The height of drain pipe must be less than 600
mm. The free end of the hose must not be immersed in water to
avoid the back flow of it.
Please securely fix the drain hose in either position D or posi-
tion E
A Back of dishwasher
B Power cable
C Drain pipe
F Inlet pipe connector
G Drain pipe
How to drain excess water from hoses
If the sink is 1000 higher from the floor, the excess water in hos-
es cannot be drained directly into the sink. It will be necessary to
drain excess water from hoses into a bowl or suitable container
that is held outside and lower than the sink.
Water outlet
Connect the water drain hose. The drain hose must be correctly
fitted to avoid water leaks. Ensure that the water drain hose is
not kinked or squashed.
Extension hose
If you need a drain hose extension, make sure to use a similar
drain hose.
It must be no longer than 4 meters; otherwise the cleaning effect
of the dishwasher could be reduced.
Syphon connection
The waste connection must be at a height less than 100 cm (max-
imum) from the bottom of the dish. The water drain hose should
be fixed .
Position The Appliance
Position the appliance in the desired location. The back should
rest against the wall behind it, and the sides, along the adjacent
cabinets or walls. The dishwasher is equipped with water supply
and drain hoses that can be positioned either to the right or the
left sides to facilitate proper installation.
Step 1a:
If only the body into cabinets, please make this map the size of
the cabinet hole.
A Electrical, drain band, water supply line entrances, both
sides
B Space of cabinet
Step 1b:
If the entire decorative panel into the cabinet also, the size of A
should be equal to D +9.5; size B should be equal to C+6;