Swim & Fun 1851 Bedienungsanleitung Seite 49

9. Troubleshooting
Pump does
not prime
correctly
or runs very
noisily:
Pressure too
low:
Technical Specifications
For technical specifications please refer tot he type plate oft he filter pump.
1851
SPS 50-1T
• 230 V / 250 W
• 117 l/min
• max. Pump height
7,5 m
• self-priming
• Connector Ø 32/38
mm
• maximum water tem-
perature 35 °C
• Integrated timer
switch
1851/1852/1853-01-2020 . swim-fun.com © All rights reserved Swim & Fun Scandinavia ApS
Lack of water.
Suction head too high.
Suction strainer (optional
accessory) blocked.
Check walve (optional ac-
cessory)
blocked.
Suction line leaky
or too much
suction head.
1852
SPS 75-1 T
• 230 V / 450 W
• 142 l/min
• max. Pump height 9 m
• self-priming
• Connector Ø 32/38
mm
• maximum water tem-
perature 35 °C
• Integrated timer
switch
Ensure there is a sufficient water
supply
– Suction line leaky.
Seal suction line, tighten screw
fittings..
Observe max, suction head.
Install check valve, fill suction line
with water
Clean, replace if necessary.
Clean, replace if necessary.
Water leaks between motor and
pump, Duocone seal worn
Replace Duocone seal.
See above.
1853
SPS 100-1 T
• 230 V / 550 W
• 158 l/min
• max.Pump
• height 10 m
• self-priming
• Connector Ø 32/38
mm
• maximum water tem-
perature 35 °C
• Integrated timer
switch
UK
49