Swim & Fun 1851 Bedienungsanleitung Seite 48

UK
8. Montage
All screw fittings must be sealed with thread sealing tape; leaks cause the priming of air, which
reduces or com-pletely prevents the priming of water. Keep suction line as short as practical, as
with increasing length the pump capacity is reduced. The suction line should ascend towards the
pump to prevent air locks. A sufficient water supply must be ensured, the foot valve at the end of
the suction line must be submerged in water at all times.
• All screw fittings should be sealed with thread sealing tape to prevent leakage
• All parts of the pressure line must be resistant to internal pressure.
• All parts of the pressure line must be installed in a workmanlike manner.
Mains Connection
Danger! Risk of electric shock! Do not operate the pump in wet environment and only under the
following conditions
• Connect only to an earthed and tested.
• Mains voltage and fuse protection must correspond with the requirement.
• The pump is to be supplied a residual current device (RCD) having a rated residual
operating current not exceeding 30mA.
• We recommend the use of RCD's as a general precaution for personal protection.
• When operating the pump outdoors the electrical connections must be
splash-proof; the connections must not be placed into water.
Start
After installation, loss of water or priming of air the pump needs to be filled with water. Starting
the pump without water causes damage!
Note:
The suction line does not need to be filled, the pump is self-priming (Exept filter pumps without
prefilter. The-se pumps are not selfpriming and have to be below the water level. For example filter
pump for the filter system Speed Clean Eco 30, Cleanmaster) However, depending on length and
diameter of the suction line it may take some time until
pressure has built up.
1. Remove the water filler plug, complete with gasket.
2. Slowly pour in clear water, until the pump is filled.
3. To reduce the time needed for priming you can also fill the suction
line.
4. Open pressure line (open tap or spray nozzle) for any air to escape during the pumping
5. Start pump
6. Turn pump OFF when water runs out steadily.
48
1851/1852/1853-01-2020 . swim-fun.com © All rights reserved Swim & Fun Scandinavia ApS