Swim & Fun 1851 Bedienungsanleitung Seite 47

Timer utilization
By adjusting the desired time (2, 4,6,10, 12, 16 or 24 hours), the pump will operate from this point
in time for the adjusted time and stand still for the rest of the 24 hours.
Within 24 hours, the filter run time can be adjusted only once. Adjusting several intervals within
24 hours is not possible.
The timer has a rechargeable battery (lithium button cell 3V CR 2032) included to save the
settings in the case of a electrical power outrage. If there will be an electrical power outra-
ge, the pump will start automatically at the next day, if the electrical power is back. The
remaining time of the filter cycle is showed on the LED of the pump.
Warning
Before replacing the battery, the pump must always be separated by pulling out
the mains plug from the mains!
Commissioning of the timer / battery change
• Use a screwdriver to tighten the screws.
• Open the cover.
• Gently press your finger to the side of the battery, this pops out freely.
• Change the battery (lithium button cell 3V CR 2032).
• Close the cover.
• Use a screwdriver to tighten the cap back on.
WARNING-INITIAL:
The already built-in battery has a protective part (plastic strips) to prevent prematu-
re discharge of the battery to. Before commissioning, it must be unlocked. If it can
not be unlocked, the timer still works flawlessly. However, be saved filter run times
will be deleted in the event of a power outage.
Initial start with external filter control
If the operation is not required with the included switch, proceed as follows. Make sure that
the battery is fully functional in the timer. Then adjust clock for 24 hours continuous opera-
tion. Now, an external timer-clock can be preceded and set arbitrarily (or several inputs and
turn-off times are now possible).
1851/1852/1853-01-2020 . swim-fun.com © All rights reserved Swim & Fun Scandinavia ApS
UK
47