Herunterladen Diese Seite drucken

Kinderkraft NUBI Benutzerhandbuch Seite 20

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 16
• This product may only be used by one child at the same time
• The parking device shall be engaged when placing and removing the children
• The maximum basket load is 2 kg.
Do not hang any bags on the parent handle.
• Any additional load suspended from the buggy handles, backrest and sides will cause stability loss.
• Use only parts and accessories supplied or recommended by the manufacturer. Do not use other parts or
accessories.
• Lift the front suspension when going up a curb or step.
• Do not place the product near open flame or other heat sources.
• Do not use with an additional platform.
• The carrying strap must not be mounted when the child is in the stroller. Children must not have access to
the stroller - danger of suffocation. The carrying strap is used to make it easier to transport the stroller
when it is folded.
• Stop using the baby carriage if you have any doubts concerning its usage or suspect any danger.
B. ASSEMBLY
I. BUGGY COMPONENTS (FIG. 1)
A. Frame
B. Leg cover
C. Safety bar
II. UNFOLDING BUGGY FRAME Place the frame (A) on a flat surface. Start unfolding the Baby stroller by
pressing the parents' handle against the Baby stroller frame so that all the elements are tightly connected.
In order to unfold the frame, slide the lock located on the parent handle, then press the button (FIG.2A) and
lift the frame upwards following the arrow in Figure 2B until you hear the locking sound.
III. ASSEMBLY/DISASSEMBLY OF SAFETY BAR, COVER, RAIN COVER, CANOPY ADJUSTMENT The safety bar
should be inserted into an appropriate opening in the seat as shown in figure 3. To disassemble, press the
button and remove the safety bar (FIG. 4). Push the leg cover over the stroller and fasten it with clips located
on the frame of the stroller. To adjust and unfold another layer of material of canopy, unfasten the zip
located on the canopy. It is possible to fasten a cover on the backrest of the stroller. To do this, attach the
loops to the canopy (FIG.20).
IV. USE OF BRAKE The buggy is equipped with a foot brake located on the rear axle. Press the lower part of
the brake down; the brake is activated when you hear the locking sound (FIG. 5A). Unlocking occurs after
lifting the lower part of brake lever (FIG. 5B).
V. LOCK OF FRONT WHEEL The front wheels can be locked for straight ahead driving. This function is
activated by moving the slider as shown in Fig. 6. To unlock the front wheels, move the slider to its initial
position. Caution! To fold the stroller, unlock the front wheels.
VI. BACK AND FOOTREST ADJUSTMENT AND CUP HOLDER ASSEMBLY The seat is equipped with smooth
backrest adjustment system, from a lying to a sitting position, using a clasp (Fig.7). The footrest has 3
positions. Pull the lever on the bottom of the footrest to change its position (FIG. 8). Cup holder is mounted
on the right side of the buggy on the stem (FIG.9).
VII. SAFETY STRAPS The buggy's straps are adapted in such a way to enable its use even by newborns. Always
use the fastening system. To secure the child insert them into the middle clasp until it engages (Fig.10).
Adjust the straps each time. Removing the straps (for cleaning): Take the shoulder and hip straps out of the
openings in the backrest.
VIII. INSTALLATION OF THE CARRYING BELT In order to attach the carrying belt, attach it to the hooks on
the frame of the folded stroller (Fig.11).
IX. REMOVING THE SEAT COVER The seat cover can be removed to wash it. First remove the roof with a
narrow tool, release the hooks on both sides (Fig. 12A) and Velcro connecting the roof with the cover. In the
next step remove the material of the cover from the hooks on the frame (Fig. 13) and remove the loops
from the canopy as shown in Fig.14 and remove the canopy. Then unfasten the straps on the bottom of the
seat (Fig. 15), remove the loops (fig. 16B) and remove the backrest height adjustment strap from the plastic
handle on both sides (Fig. 17). In the next step, remove the cover from the safety devices on both sides of
D. Cup holder
E. Rain cover
F. Carrying strap
20

Werbung

loading