ConDTrol sMarT 2D Green
en
Cross line laser
user manual
Check of vertical line
use a plumb bob as a reference of a vertical. Place the instrument at
distance of 1,5m from the plumb bob.
1. move lever lock to unlocked position
, then switch on vertical
plane and align vertical laser line with the low point of plumb bob.
2. if deviation between the laser line and the plumb line exceeds ±0.5
mm per 1m of the plumb bob length (for a 2.5m plumb bob deviation
shouldn't exceed 1.25mm) please contact service center.
12