Digital Rocking/Waving Shaker Operating Instructions - OHAUS SHRK07AL1 Bedienungsanleitung

DIGITAL ROCKING/WAVING SHAKER OPERATING INSTRUCTIONS

The Rocking/Waving Shakers have been designed for the speed/tilt angle and
time functions to work independently of one another. The speed/tilt angle can be
reset without resetting the timer and the timer can be stopped and started without
interrupting the rocking/waving function.
1. Getting ready:
a. Plug the power cord into a properly grounded outlet. The standby indicator
light will illuminate, verifying power to the unit. Manually move the tray to a near
horizontal "home" position before powering unit.
b. Press the standby button to move the unit from standby mode. The standby
indicator light will turn off and the speed/tilt angle and time displays will
illuminate, displaying the previously used settings.
2. Setting tilt angle: Electronic tilt enables the user to adjust the angle of tray
movement while the unit is rocking/waving or while the unit is stopped.
a. Press the function button below the speed/tilt angle display until the tilt indicator
light illuminates. You are now ready to set the tilt angle.
b. Press the up/down arrows below the speed/tilt angle display until you reach
the desired angle. When you release the button, the display will blink off and
then on indicating the new set angle has been accepted. The unit will complete
one rotation at the previously set angle, then smoothly change to the newly
programmed angle. The tilt indicator light will flash until the transition to the new
tilt angle is complete.
3. Setting speed:
a. Press the function button below the speed/tilt angle display until the speed
indicator light illuminates. You are now ready to set the speed.
b. Press the up/down arrows below the speed/tilt angle display until you reach the
desired speed. When you release the button, the display will blink off and then
on indicating the new set speed has been accepted.
9
1.800.561.8187
c. Press the on/off button to start the rocking/waving function. The indicator light
d. To stop the rocking/waving function, press the on/off button below the speed/tilt
OPERATING TIPS
When the unit is running at slow speeds or high angles, making large changes to
the tilt angle or speed may take several minutes to complete. The quickest way to
make large changes is to stop the unit, change the speed or tilt angle, then restart by
pressing the on/off button below the speed/tilt angle display.
4. Setting time to zero (0:00) and continuous mode: Accumulated time.
a. Press and hold the on/off button below the time display. After three (3) seconds
b. Simultaneously press both the up and down arrows, the display will indicate
c. Press the on/off button below the time display. The display will indicate
d. To reset, press and hold the on/off button below the time display. After three (3)
www. .com
below the speed/tilt angle display will illuminate and blink until the set-point is
reached. Once the set-point is reached the light will stop blinking and remain lit
until rocking/waving has ceased.
angle display. The unit will complete one full rotation then stop in the horizontal
"home" position. The speed indicator light will flash until the rotation is complete.
When the cycle is complete, the unit will automatically move to standby mode
and the standby indicator light will illuminate.
the display will indicate the previous set time.
zero (0:00). The unit time is now set to zero (0:00) minutes. Alternately, you can
use the up/down arrows to get to zero (0:00).
accumulated time. The up/down arrows will become inactive. To stop timer,
press the on/off button again. IMPORTANT: This will NOT interrupt the rocking/
waving function. Press the on/off button below the speed/tilt angle display to
interrupt the rocking/waving function.
seconds the display will indicate the previous set time, which was zero (0:00).
information@itm.com
EN