Switching Rubber Grips; Installing The Batteries; Charging - Spektrum DX2S Bedienungsanleitung

swITChIng rubber grIps

The DX2S is supplied with three different sized rubber
grips with the medium size installed on the transmitter.
Each grip's size is identified with an "S" (small), "M"
(medium), or "L" (large) on the inside of the grip for
easy identification. To remove, simply lift the edge of the
grip and continue around the grip until it is completely
removed. To replace, align the tabs of the grip to the slots
in the handle and press the grip in place.

InsTallIng The baTTerIes

The DX2S radio system is supplied with 4 AA alkaline
batteries required for operation that provide over 16
hours of run time. Many drivers prefer alkaline batteries
over rechargeable batteries finding it more convenient to
simply replace the batteries when depleted rather than
taking the time to recharge them.
Optional NiMH 1.2-volt AA rechargeable batteries
(SPM9525) can also be used. A charge jack located
opposite of the on/off switch is provided for convenient
recharging with Spektrum charger SPM9526.
Remove the battery door and install 4 AA batteries
observing the polarity marked on the battery holder.
Replace the battery door.
SPEKTRUM DX2S USER GUIDE

ChargIng

Charger Pigtail for Transmitter
BLACK TO POSITIVE
BLACK W/WHITE STRIPE TO NEGATIVE
Spektrum Transmitter Charge Jack Polarity
-
A charging jack is located on the opposite side of the on/
off switch. If rechargeable batteries are used they can be
conveniently charged without removing them from the
transmitter using the charge jack.
IMPORTANT: All Spektrum charge jacks are
center-pin negative. This is opposite of many
chargers. Before using a charger, make sure
the connector is center-pin negative. This
can be done using a voltmeter. Also, unlike
conventional radio systems that use 8 cells to
power the transmitter, the DX2S uses 4 cells.
This is due to the electronics being more
efficient. When charging, be sure to use a
charger designed for 4 cells (a 4.8-volt battery
pack) when charging the transmitter. Many
drivers simply make a harness and use the
same charger used to charge their car packs
but turn the current rate down to 1 to 2 amps.
Warning: C harge only rechargeable batteries. Other
types of batteries may burst causing injury to
persons and/or damage to property. Risk of
fire and electric shock. Dry location use only.
EN
+
5