System - Spektrum DX2S Bedienungsanleitung

EN

sysTeM

The System function allows selection of the RS Port on
the receiver to function as the bind port or auxiliary port,
display of the List screen in Expert mode or Standard,
voltage alarm threshold to be set, Throttle Trim to act as
throttle or brake trim, contrast to be adjusted, and buzzer
loudness to be set.
To aCCess sysTeM
In the List screen rotate the Rolling Selector to highlight
the System function.
Press the Rolling Selector to access the System function.
RS Port
The RS Port function allows the Remote Start feature
(available in the future on remote start compatible
vehicles) to be enabled on either the Bind port or
Auxiliary channel port of the SR3300T using the
Remote Start Button.
List
List selects either an Expert or Standard screen to be
displayed. The Expert selection enables all functions
to be displayed on the List screen. The Standard List
selection enables seven commonly used functions
including: Model Select, Model Name, Travel, Reverse,
Sub Trim, Bind, and System.
20
Alert
The Alert sets the voltage threshold of the transmitter's
battery pack at which the transmitter's alarm sounds.
Throttle: TRIM
Selects how the TH Trim switch function behaves. The
default function acts as a throttle trim. The alternative
BRAKE function enables it to act as full (panic) brake trim.
Contrast
The contrast function provides adjustment to the bright-
ness ratio of the lightest to the darkest part of the screen.
Buzzer
The buzzer function is used to control the loudness
of the buzzer.
Language
Either English or German can be selected as the language.
To access the above functions use the Rolling Selector
and select the desired system function. Press the Rolling
Selector and the surrounding box will flash. Rotate the
Rolling Selector to make your adjustment then press the
Rolling Selector to select the value.
Frame Rate
The DX2S features two frame rates allowing it to be
compatible with all types of servos (older analogs through
the latest digitals).
11ms: Offers fast response rates and is compatible with
most digital and analog servos (this is the default rate).
16.5ms: This is a lower response rate and is needed for
older analog servos.
RF Mode
Std is the standard RF mode. FR is the France RF mode
and should only be selected if the transmitter is used in
France.
To return to the main screen press and hold the Rolling
Selector for more than three seconds.
SPEKTRUM DX2S USER GUIDE