Programming In 7-Day Mode - Danfoss TP7000 + RF Installationsanweisungen/Inbetriebnahme-Instruktion

The unit is now in RUN mode (colon flashes in
GB
display) and the heating will operate according
to the preset programmes.
Before you change the preset programmes
Your installer will have set your unit to operate in either 7-day mode
or 5/2 day mode. To tell which mode your unit is set press PROG until
Event 1 flashes in the display.
1
1 2 3 4 5

Programming in 7-day mode

(separate programmes for each day of the week)
a) Press PROG until Event 1 flashes, then press
DAY to move from current day to Day 1.
b) Amend the time and temperature as
follows:
Use + and – buttons to alter time
i)
(press and hold to change in 10 min
increments).
ii) Use
temperature in 0.5°C (1°F) steps.
iii) Press NEXT to advance to next Event.
iv) Repeat steps i,ii & iii above for Events 2,
3, 4, 5 & 6.
10
This unit is in 7-day mode and you can programme
different settings for each day of the week (see page 10-
11).
This unit is in 5/2 day mode and you can enter one of
set of programmes for weekdays and another set for
weekends (see page 11).
and
buttons to alter
1