Electrical Connection; Motor Protection Filter; Switching Off - BOMANN bs 984 cb Bedienungsanleitung

Adjusting the Height of the Floor Nozzle
Select a setting between fl oor coverings with:
high
pile

Electrical Connection

• Unwind the required cable length and insert the mains plug
into a standard 230 Volt, 50 Hertz wall socket.
NOTE:
The holders for the cord take-up can be turned through 180°
so that you can take off the cord faster.
Position in Use
• Place your foot on the
unlocking button (1) to
move the handle into the
required position.
• Switch the device on with
the on/off switch (10).
Instructions for Use
NOTE:
Now you should vacuum at an even speed. Pressing hard is
not necessary.
CAUTION:
Pay attention to the restricted range due to the length of the
cable!
Avoid damaging the surface being cleaned:
• Do not set the brushes too low!
• Do not allow the machine to remain stationary when
switched on!

Switching off

• Move the handle to a vertical position.
• Switch the device off using the on/off switch.
• Remove the plug connector from the plug socket.
• Use the cable take-up to stow away the cable.
Filter
Your machine has three fi lter systems.
1. Transparent dust collection container
The traditional dust bag system has been replaced by a
transparent dust collection container in which coarse dirt
particles and tiny particles fl oating in the air are swirled out
of the suction air by the high speed of the air current.
32
05-BS 984 CB 32
medium pile smooth fl oor
The quantity of dust can be easily read off at any time on
the container, which is also very easy to empty.
The purchase of dust bags is no longer necessary.
2. Main Filter, Pre-fi lter (in the Dust Container)
WARNING:
Before removing and cleaning the fi lters switch the device
off and remove the plug from the socket.
Once the dust level has reached the MAX mark of the dust
container, please proceed as follows:
1. Press the button (3).
2. Remove the dust container.
3. Empty the contents of the dust container into a suitable
receptacle by pressing button on the dust container.
(See illustration a.)
NOTE:
Every third time that the fi lters are emptied, or in the
case of severe soiling, clean the fi lters by allowing wa-
ter to fl ow through them against the direction in which
the air blows. The fi lters should only be re-inserted
when they are completely dry!
4. To do so, release the lid with the main fi lter (b).
NOTE:
By means of short turns in a clockwise or
anticlockwise direction the following components can
be removed or separated.
5. Remove the main fi lter (c). This fi lter can also be
cleaned from time to time with the brush.
6. Remove the pre-fi lter (d). These components can be
separated once more (e).
7. When the components have been cleaned and dried
they can be reinstalled. Connect the components again
by short turns in a clockwise or anticlockwise direction.

3. Motor Protection Filter

Clean the fi lter felt on the bottom of the dust housing every
time you empty the vacuum.
NOTE:
Every third time that the fi lters are emptied, or in the case
of severe soiling, clean the fi lters by allowing water to
fl ow through them against the direction in which the air
blows. The fi lters should only be re-inserted when they are
completely dry!
15.02.2007, 15:27:19 Uhr