1.
Important information
1.1
Scope of delivery
The delivery of Foam Removal Tool comprises:
Tool d32 – d90 / d110 – d225, including components and case
•
Instruction manual - foam removal tool
•
d32 – d90 / d110 – d225
1.2
Documentation
EN
The following documents are part of the product and must be considered:
GF Planning Fundamentals COOL-FIT 2.0 / COOL-FIT 4.0
•
The document can be obtained via your local GF Piping Systems representative or under
www.gfps.com
1.3
Signs and symbols
Symbol
>
2.
Safety
The assembly instructions are part of the GF product and must be read carefully before
assembly. The assembly instructions must be available at all times.
2.1
Intended use
The Foam Removal Tool is appointed to dismantle and peel COOL-FIT 2.0, COOL-FIT 2.0F,
COOL-FIT 4.0 and COOL-FIT 4.0F pipes.
2.2
Target group and qualification
The Foam Removal Tool may only be used by professionals who are trained regularly in
work safety and environmental protection on pressurized piping systems.
2.3
Safety information
Damage to property
An incorrectly installed piping system may cause damage to property.
Pipes have to be installed correctly
>
Piping system has to be checked regularly
>
Violation of local and country-specific regulations, guidelines and standards can cause
damage.
3.
Transport and storage
The Foam Removal Tool and the individual tool components must be stored and
transported in original case.
26
Meaning
Action required
Perform visual check (e.g. of pipes)