Troubleshooting; Spindle Taper Can Not Be Mounted In The Pipe; Spindle Taper Can Not Be Fixed In The Pipe / Is Not Taut - GF COOL-FIT Bedienungsanleitung

8.

Troubleshooting

5.2 Spindle taper can not be mounted in the pipe

Possible cause
The pipe was not trimmed at the
inner diameter.
The spindle taper is already
under tension.
The spindle taper was wedged
into the pipe during installation.
The wrong dimension for the
clamping shoe has been selected.
The clamping shoe were
mounted incorrectly.
The number of clamping shoe are
not completely assembled or
available.
Clamping shoe can not be assem-
bled (missing magnetic fixture).
The pipe is damaged and the
ovality on it is too high.

5.2 Spindle taper can not be fixed in the pipe / is not taut

Possible cause
The spindle taper is dirty and can
not rotate the handle.
The spindle taper is dirty at the
clamping shoe and wedges.
It is a mechanical defect (no
power transmission or clamping
the shoe is not possible).
Solution
Check the pipe and, if necessary, deburr the
inner diameter with deburring tool.
Check spindle taper and rotate into relaxed
position.
Check spindle taper and rotate in the relaxed
position and re-assemble in the pipe (making
sure that the spindle taper is not wedged).
Check the clamping shoe dimension. Select and
assemble the right clamping shoe dimension.
Check that pipe stops of the clamping shoe are
on the right side and, if necessary, correct.
Mount missing clamping shoe or order missing
shoe and retrofit (if not present).
Contact local GF service center and send the
tool to the GF service center.
The pipe must be checked. If the pipe is
damaged at the pipe ends, remove the damaged
part. If the entire pipe is damaged (for example,
crimped), use a new undamaged pipe.
Solution
Clean the spindle taper on the outside with a
broom or brush. If the spindle taper continues
to not turn the handle, contact the GF service
center and send tool to theyour local GF service
center.
Clean the spindle taper on the outside with a
broom or brush. If the spindle taper continues
to not turn the handle, contact the GF service
center and send tool to the GF service center.
Contact GF service centre and send tool to the
GF service center.
EN
39