Werbung
Verfügbare Sprachen
Verfügbare Sprachen
If you select CABLE option, the following screen will
be displayed:
You can select frequency ranges from this screen. For
highlighting lines you see, use " " or " " button. You
can enter the frequency range manually by using the
numeric buttons on the remote control. Set Start and
Stop Frequency as desired by using numeric buttons
on the remote control. After this operation, you can set
Search Step as 8000 KHz or 1000 KHz. If you select
1000 KHz, the Tv will perform search process in a
detailed way. Searching duration will thus increase
accordingly. When nished, press OK button to start
automatic search. Automatic searching screen will be
displayed during the process.
Note: If you select an extended gap between Start
and Stop frequency rate, automatic search duration
will take a longer time.
If you select AERIAL option from the Search Type
screen, the digital television will search for digital
terrestrial TV broadcasts:
The IDTV will automatically tune to the UHF or VHF
(** for EU countries) transmission channels, searching
for digital terrestrial TV broadcasts and displaying the
names of channels found. This process will take about
a few minutes. To cancel searching, you can press the
"MENU" button at any time during the process.
Note: If the digital TV fails to store any channels, "No
channels available." message will be displayed on
the screen.
Either you select AERIAL or CABLE option from the
search type menu, after the digital automatic search is
completed, the following message asking for analogue
channel search appears on the screen:
To search for analogue channels, select "Yes". TV
switches to the analogue TV mode. A menu will be
displayed to search for analogue channels.
Set Language item by pressing " " or " " button.
Press " " or " " button to highlight Country item and
then use " " or " " to set. Press " " or " " button to
highlight TXT. Language. Set TXT Language by using
" " or " " button. To cancel, press the BLUE button.
When nished, press OK or RED button to continue
and the following OSD will be displayed:
After automatic tuning is nalized, a programme list
will appear on the screen. In the programme list you
will see the programme numbers and names assigned
to the programmes.
If you do not accept the locations and/or the names
of the programmes, you can change them in Program
table. For details, see the section, "Program table".
General Operation
Press the "SOURCE" button and select DTV/USB
from the list. The TV then switches to digital TV mode.
Information Banner
• Whenever you change the channel using the P +
or P - button or numeric buttons, the TV displays
the broadcast picture along with an information
banner at the bottom of the screen. Broadcast type
information is also displayed. This will remain on the
screen for approximately a few seconds.
• The information banner can also be displayed
by pressing the "INFO" button at any time while
watching the TV. Pressing "INFO" button again
removes the banner.
If the selected channel is locked, you must enter
the correct four digit key to view the channel. In this
case, a dialog box asking for the lock key will be
displayed:
English - 59 -
Werbung
Kapitel
