Starting The Engine; Using The Self-Propel Drive; Shutting Off The Engine; Mulching The Clippings - Toro 21750 Bedienungsanleitung

Starting the Engine

1. Hold the blade-control bar against the handle (A of
2. Pull the recoil-start handle (B of
Note:
When you pull the recoil-start handle, pull it lightly until you feel resistance, then pull it sharply.
Allow the rope to return to the handle slowly.
Note:
If the machine does not start after several attempts, contact an Authorized Service Dealer.

Using the Self-Propel Drive

•
To engage the self-propel drive, pull the
self-propel-drive bar to the handle and hold it
(Figure 13).
Figure 13
1. Self-propel-drive bar
Note:
The maximum self-propel-drive speed is
fixed. To reduce the speed, increase the space
between the self-propel-drive bar and the handle.
•
To disengage the self-propel-drive, release the
self-propel drive bar.
Note:
To reduce the ground speed, increase the
space between the self-propel drive bar and the
handle.
Figure
Figure 12).
Figure 12

Shutting Off the Engine

To shut off the engine, release the blade-control bar.
Note:
when you leave the machine.
Important:
bar, the engine should shut off and the blade
should stop within 3 seconds. If they do not, stop
using your machine immediately and contact an
Authorized Service Dealer.

Mulching the Clippings

g240765
Your machine comes from the factory ready to mulch
the grass and leaf clippings back into the lawn.
If the grass bag is on the machine, remove it before
mulching the clippings. Refer to
Bag (page
12
12).
Remove the key (if equipped) from the ignition
When you release the blade-control
13).
g230255
Removing the Grass