Setup; Installing The Handle; Installing The Recoil-Starter Rope In The Rope Guide - Toro 21750 Bedienungsanleitung

Setup

Important:
Remove and discard the protective plastic sheet that covers the engine and any other
plastic or wrapping on the machine.
Important:
To prevent accidental starting, do not insert the key into the electric-start ignition (if
equipped) until you are ready to start the engine.
1

Installing the Handle

No Parts Required
Procedure
WARNING
Folding or unfolding the handle improperly can damage the cables, causing an unsafe
operating condition.
• Do not damage the cables when folding or unfolding the handle.
• If a cable is damaged, contact an Authorized Service Dealer.
1. Remove the handle knobs and corresponding bolts from the lower handles (A of
2. Position the upper handle on the lower handles and then unfold the handle (B of
3. Ensure that the cables are routed to the outside of the handle (C of
4. Install the handle knobs with the corresponding bolts and tighten them firmly by hand (D of
2

Installing the Recoil-Starter Rope in the Rope Guide

No Parts Required
Procedure
Important:
To start the engine safely and easily whenever you use the machine, install the recoil-starter
rope in the rope guide.
Figure 3
4
Figure 3).
Figure 3).
Figure 3).
Figure 3).
g305902