Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Connecting to a DVD Player
via Component Sockets
(YPbPr) or Scart Cable
•
Some DVD players are connected through
COMPONENT SOCKETS (YPbPr). YPbPr can be
used only when you connect a device that has a
YPbPr output through the PC input with YPbPr to
PC cable (YPbPr cable is not supplied).
•
When the connection is made, switch to YPbPr
source. See, "Input selection" section.
•
To enable audio connection, use the
Component Audio cable. First, plug single jack
of the cable to the TV. Afterwards, insert your DVD
player's audio cable's connectors into the plural part
of the VGA/Component audio connection cable
(see illustration below). Colours of the connected
jacks should match ( RED & WHITE).
•
When the connection is made, switch to
See, Input selection section.
•
You may also connect through the
•
Note
: These three methods of connection perform the
same function but in different levels of quality. It is not
necessary to connect by all three methods.
Remote Control Handset
Inserting Batteries
•
Remove the battery cover located on the back of
the handset by gently pulling backwards from the
indicated part.
•
Insert two
inside. Observe the correct polarity (+/-) when
inserting batteries and replace the battery cover.
VGA/
Note: Remove the battery from remote control
handset when it is not to be used for a long period.
YPbPr source.
Otherwise it can be damaged due to any leakage of
batteries. Remote range is approximately 7m/23ft.
SCART input.
Switching On/Off
To Switch the TV On
•
Connect the power cord to the 220-240V AC, 50 Hz.
Then the standby LED lights up.(The led will blink
during the standby On/Off)
•
To switch on the TV from standby mode either:
•
Press the "
on the remote control.
•
Press the "
TV will then switch on.
Note: If you switch on your TV via PROGRAMME
UP/DOWN buttons on the remote control or on the
TV set, the programme that you were watching last
will be reselected.
By either method the TV will switch on.
To Switch the TV Off
•
Press the "
the "
standby mode.
•
To power down the TV completely, unplug the
power cord from the mains socket.
Note: When the TV is switched to standby mode,
standby LED can blink to indicate that features such
as Standby Search, Over Air Download or Timer is
active.
English - 54 -
AAA/R3 or equivalent type batteries
" button, P+ / P- or a numeric button
" button, - or + button on the TV. The
" button on the remote control or press
" switch on the TV, so the TV will switch to
Werbung
Kapitel
Inhaltsverzeichnis
