Faults - What To Do - Siemens KI S-Serie Gebrauchsanleitung

en Faults – what to do?
3
Faults – what to do?
Before you call customer service, use this table to check whether you can rectify the
d o ? F a u l t s – w h a t t o
fault yourself.
Temperature differs greatly from the set value.
Displays do not illuminate.
The mains plug has not been inserted properly.
The fuse has tripped.
The power has failed.
Display indicates "E...".
Electronics have detected a fault.
A warning signal sounds and the alarm button is lit.
Appliance door is open.
Ventilation openings have been covered.
Large quantities of fresh food were placed in the
appliance.
Display flashes, warning signal sounds and button alarm is lit.
Appliance door is open.
Ventilation openings have been covered.
Large quantities of fresh food were placed in the
appliance.
40
Switch off appliance for 5 minutes.
~ "Switching off and disconnecting the appliance"
on page 32
If the temperature is too warm, check temperature
again after a couple of hours.
If the temperature is too cold, check temperature
again on the following day.
Connect the mains plug.
Check the fuses.
Check whether the power is on.
Call the customer service.
~ "Customer service" on page 42
Press the alarm button. Alarm is switched off.
Close the appliance door.
Clear ventilation openings.
Do not exceed max. freezing capacity.
Press the alarm button. Alarm is switched off.
Close the appliance door.
Clear ventilation openings.
Do not exceed max. freezing capacity.