Preventing Noises; Faults - What To Do - Siemens KIN-Serie Gebrauchsanleitung

Preventing noises

Appliance is not level: Align appliance
using a spirit level. If required, place a
little packing underneath.
3
Faults – what to do?
Before you call customer service, use this table to check whether you can rectify the
d o ? F a u l t s – w h a t t o
fault yourself.
Temperature differs greatly from the set value.
Displays do not illuminate.
The mains plug has not been inserted properly.
The fuse has tripped.
The power has failed.
Display indicates "E...".
Electronics have detected a fault.
Appliance is not cooling, display and lighting are lit.
Showroom mode switched on.
--------
Containers, shelves or storage
compartments wobble or stick: Check
the removable fittings and re-insert if
required.
Bottles or receptacles are touching
each other: Move bottles or receptacles
away from each other.
Switch off appliance for 5 minutes.
~ "Switching off and disconnecting the appliance"
on page 28
If the temperature is too warm, check temperature
again after a couple of hours.
If the temperature is too cold, check temperature
again on the following day.
Connect the mains plug.
Check the fuses.
Check whether the power is on.
Call the customer service.
~ "Customer service" on page 36
Start the appliance self-test.
~ "Customer service" on page 36
When the programme has ended, the appliance
switches over to normal operation.
Faults – what to do? en
35