Basic Operation - Bosch MUZS2FWW Gebrauchsanleitung

Set up the base unit as described
1.
in the main operating instructions.
Press the release button and move
2.
the swivel arm down until it en-
gages in the vertical position.
→ Fig.
3
a The swivel arm is fixed in posi-
tion 3.
Rotate the base unit to the operat-
3.
ing position.
→ Fig.
4
Inserting the seal
Insert the seal into the housing
▶
and press in firmly.
→ Fig.
5
The recesses must match up ex-
actly.
Assembling the attachments
Note: To use the special accessory,
you need the parts of the meat min-
cer, except for the knife and perfor-
ated disc.
Assembling the meat mincer
Fit the worm gear into the housing
1.
with the agitator paddle at the
front.
→ Fig.
6
Fit the knife onto the worm gear
2.
with the square projection at the
front.
→ Fig.
7
Insert the required perforated disc
3.
into the housing.
→ Fig.
8
Observe the recess on the perfor-
ated disc.
Fit the threaded ring and tighten
4.
clockwise slightly.
→ Fig.
9
1
Special accessory
Assembling the juicer attachment
Follow the illustrated instructions.
→ Fig. -
10 14
Assembling the Viennese whirl
1
attachment
Follow the illustrated instructions.
→ Fig. -
15 18
Assembling the grater attachment
Follow the illustrated instructions.
→ Fig. -
19 22
Fitting the attachment
Open the locking lever.
1.
→ Fig.
23
Hold the prepared attachment hori-
2.
zontally and match up the ends of
the agitator paddle with the drive.
→ Fig.
24
Push the attachment fully onto the
3.
drive.
Rotate the attachment anticlock-
4.
wise as far as possible.
→ Fig.
25
Close the locking lever.
5.
→ Fig.
26
Tighten the threaded ring clock-
6.
wise.
Attach the filling tray.
7.
→ Fig.
27
Place a suitable container under
8.
the attachment.
→ Fig.
28

Basic operation

Basic operation
You can find out everything you need
Basic operation
to know about operating your ac-
cessory here.
Basic operation en
1
1
19