Messages - Sony DSX-A212UI Bedienungsanleitung

Messages

The following messages may appear or flash during
operation.
HUB NO SUPRT: USB hubs are not supported.
INVALID
 The selected operation could be invalid.
 [USB MODE] cannot be changed during iPod
playback.
IPD STOP: iPod playback has finished.
 Operate your iPod/iPhone to start playback.
NO AF: No alternative frequencies.
 Press  (SEEK –/+) while the program
service name is flashing. The unit starts searching
for another frequency with the same PI (program
identification) data ([PI SEEK] appears).
NO TP: No traffic programs.
 The unit will continue searching for available TP
stations.
NOT SUPPORT - ANDROID MODE
 A USB device not supporting AOA (Android Open
Accessory) 2.0 is connected to the unit while [USB
MODE] is set to [ANDROID].
 Set [USB MODE] to [MSC/MTP] (page 12).
OVERLOAD: The USB device is overloaded.
 Disconnect the USB device, then press SRC to
select another source.
 The USB device has a fault, or an unsupported
device is connected.
READ: Now reading information.
 Wait until reading is complete and playback
starts automatically. This may take some time
depending on the file organization.
USB ERROR: The USB device cannot be played.
 Connect the USB device again.
USB NO DEV: A USB device is not connected or
recognized.
 Make sure the USB device or USB cable is securely
connected.
18
GB
USB NO MUSIC: There is no playable file.
 Connect a USB device containing playable files
(page 15).
USB NO SUPRT: The USB device is not supported.
 For details on the compatibility of your USB
device, visit the support site on the back cover.
For steering wheel remote control
operation:
ERROR: An error occurred during the function
registration.
 Register again from the function where the error
occurred (page 12).
TIMEOUT: The function registration failed due to a
timeout.
 Try completing the registration while [REGISTER]
is blinking (about 6 seconds) (page 12).
For firmware update operation:
FILE ERROR: The updater is not stored in the USB
device.
 Store the updater in the USB device, then try
again (page 13).
UPDATE ERROR PRESS ENTER: Firmware update is
not completed properly.
 Press ENTER to clear the message, then try again.
During the update, do not turn the ignition to the
OFF position, nor remove the USB device
(page 13).
 Insert the USB device storing the updater, and
then press ENTER.
If these solutions do not help improve the situation,
consult your nearest Sony dealer.