Power Supply; Safety Devices; Product Description - ims PRO POWERDUCTION AUTO Bedienungsanleitung

Translation of the original instructions
IDENTIFICATION
On the back of the product is the following information:
• Manufacturer's name and address
• Model
• Product serial number
• Operating voltage
• Product power
Model and serial numbermust be mentioned each time a technician intervention is required or if spare parts are
requested.

POWER SUPPLY

The Powerduction Auto is fitted with a 16A socket type CEE7/7 which must be connected to a single-phase 230V (50/60
Hz) power supply fitted with three wires and one earthed neutral.
Check that the power supply and its protection (fuse and/or circuit breaker) are compatible with the current needed by
the machine. The product is protected for operation on a generator.

SAFETY DEVICES

• The product has the safety feature PROTEC 400. It is protected against overvoltage above 300V and against neutral
disconnection.
• During intensive use, the inductor, cables, electronics and power transformer heat up. In order to avoid dysfunction
due to overheating, the Powerduction Auto is equipped with an air cooling circuit. A thermal protection also switches
off the product when the internal temperature becomes too high.
• The inductors are insulated to protect the user against possible electric shock..
• The Powerduction Auto is equipped with a safety device against accidental heating. If the heating control is inad-
vertently activated (pressure on the control pedal or glass inductor control button), and the inductor is not in contact
with the metal to be heated for a time exceeding one minute, then the unit will beep and switch off automatically.
Release the heater control to go back to a normal heating cycle.

PRODUCT DESCRIPTION

Powerduction Auto is made up of an inductor connected to an alternating medium-frequency power source. When a
heating control is switched on, a strong magnetic field is emitted by the inductor. When approaching a ferrous metal,
the inducted currents will create heating in the metal, without physical contact.
POWERDUCTION AUTO can be used for many applications (depending on the selected inductor):
- to remove all logos, adhesives, mouldings, plastic rods glued to bodywork.
- unbolt and unlock metal parts (bolts, screws, connecting rods...).
- remove bonded glass (rear glass, rear quarter, panoramic roof).
- Remove rubbing strips and seals.
The product will heat steel, but is not suitable for heating Aluminum, copper or zinc.
OPERATING INSTRUCTIONS
2
1
10
16
POWERDUCTION AUTO
3
4
5
7
8
9
1 Setting controls
2 Digital display
3 Power-on indicator
4 Auto mode indicator
5 Manual mode indicator
6 Max. power indicator
6
7 Selection mode button
8 Thermal protection indicator
9 Optimal heating area
10 «No load» indicator
EN